Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.
Manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold, don’t forget spare tyre, remember to refit valve caps.
The head restraint should be adjusted so the rigid part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of the head as is comfortable. Note: Some restraints might not be adjustable.
No cuts and bulges, 1.6mm of tread depth across the central three-quarters of the breadth of the tyre, and around the entire outer circumference of the tyre.
Explain you’d operate the switch (turn on ignition if necessary), then walk round vehicle (as this is a ‘tell me’ question, you don’t need to physically check the lights).
Warning light should illuminate if there is a fault with the anti-lock braking system.
Explain you’d operate the switch (turn on ignition if necessary), and then walk round vehicle (as this is a ‘tell me’ question, you don’t need to physically check the lights).
Explain you’d operate the brake pedal, make use of reflections in windows or doors, or ask someone to help.
If the steering becomes heavy, the system may not be working properly. Before starting a journey, 2 simple checks can be made.
Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Operate switch (turn on dipped headlights and ignition if necessary). Check warning light is on. Explain that they would be used when visibility is reduced to less than 100 metres.
Operate switch (with ignition or engine on if necessary), check with main beam warning light.
Identify dipstick, describe how you’d remove it and wipe clean, then reinsert and remove to check level of oil against the minimum and maximum markers.
Identify high and low level markings on the tank where fitted or radiator filler cap, and describe how to top up to correct level.
Identify reservoir, check level against high and low markings.
You need to open the bonnet and tell the examiner how you’d do the check if you’re asked question 1
Copyright © 2021 Dan Reed School of Motoring - All Rights Reserved.
Who doesn't like cookies? This website is no different! By continuing to use this site, you accept our use of cookies. Privacy Policy